Setting solution for decals

Softens decals to conform to irregular surfaces for a painted on look

Micro Sol setting solution is for the most difficult irregular surfaces to be found on models. It
completely softens the Microscale Decal, allowing it to drape down onto the surface of the
model, conforming perfectly to surface irregularities without distortion. The most amazing
results in seemingly impossible places are possible because Micro Sol actually makes the decal
part of the painted surface. For that reason you should coat Micro Sol on for only a few
seconds and then leave it alone. It does the work. Do not touch until the decal has dried, as the
decal is very soft at this stage and could be easily damaged.
For the best results, first apply Micro Set to prepare the surface and enhance the adhesive.
Make sure the surface is free of particles that could get under the decal’s film and cause a
blemish. Then, when everything is dry enough that the decal will not move easily, apply Micro
Sol with a small flat brush. Apply with as few strokes as possible so as not to disturb the decal.
Then allow the decal to dry without disturbing it. One application is enough in most cases but, if
necessary, a second application of Micro Sol can be helpful. Following these simple
instructions will result in a model with professional looking markings.